If your RV is wired correctly, then the circuit breakers will keep you from drawing too many amps from shore power (by ‘popping’ a breaker).
However, the AC units and the microwave are the biggest consumers of amperage/power so I’m not sure you could run all three at one time even in a perfect shore power situation. So if you are getting the theoretical maximum of 45 amps using the Camco plug AND your rig uses less than 45 amps for the two air conditioners and the microwave, then you should be fine. So the RV will use the incoming power as needed. In other words, it provides power to one location on your RV, just as if you had plugged into a 50-amp receptacle. The adapter “feeds” the single shore power inlet of your RV.
#HOOKING UP 30 AMP RV PLUG PLUS#
They claim you will then have up to 45 amps (30-amp plus 15-amps) to use.Īs far as being able to power certain systems off the 30-amp and other systems off the 15-amp, that isn’t how these types of adapters work. View that item here on the Camco website. It sounds like they don’t recommend doing what you are inquiring about.Ĭamco makes an adapter that has a 15-amp and a 30-amp male plug and a 50-amp female plug, which sounds like exactly what you are looking for. It is also your responsibility to test and monitor power usage to your RV/equipment.” It will not work on GFCI protected outlets. It is your responsibility to verify if this product will work with the wiring you are connecting to. “It is recommended that you use this adapter to plug into separate 30A circuits. Note that on this page they say the following: I assume you have a 30-amp/30-amp (so dual 30-amp male plugs) into a single 50-amp female adapter like this.
#HOOKING UP 30 AMP RV PLUG SKIN#
When you are standing on the ground, your body is forming the ground circuit for the RV that has the hot skin condition. To detect (or feel) a hot skin condition, you have to be standing on the ground and touching a metal part of the RV with the detection tool. This device will prevent power from reaching your RV (and causing hot skin) if there is a problem with the power source (improperly wired, etc). You can protect your rig, and yourself, from a hot skin condition caused by an improperly wired power pedestal by using an RV surge protector. So if you are out boondocking and only have the 12-volt system humming along, you won't experience a hot skin condition. You only have to worry about this condition if you are plugged into a 120-volt power source (shore power or generator). Hot skin is caused by an incorrectly wired power pedestal (shore power source), damaged RV power/extension cord, and/or wiring damage internal to the RV itself. It can range from either a mild electrical tingling sensation to a massive shock that could potentially put you into cardiac arrest. Hot skin is when your RV is electrified (any metal portion of the rig) due to a faulty electrical ground. There is an electrical danger caused by an incorrectly grounded RV that is known as 'hot skin' condition. It also offers 1050 Joules of voltage surge protection. This is available for 30-amp receptacles only (you can use an RV surge protector if you have a 50-amp plug) and checks the condition of the ground, neutral and hot-wiring, as well as checks for correct polarity. If you want to only have the bare minimum to allow you to check the outlet condition, you can use the Camco Power Defender circuit analyzer. It's well worth the money to have this kind of electrical protection for your rig!
It will tell you if the outlet is safe to plug into, and it can protect you from voltage spikes, low and high voltage conditions, and more. We recommend that you use a good RV surge protector (or more specifically, an electrical management system). Such an event can cause major damage to your RV's electrical system. It isn't unheard of for a power pedestal (or other power source outlet) to be wired incorrectly. You are playing with fire (literally) if you don't check your power source before you plug your rig in.
0 kommentar(er)
